© Copyright Our Wall
Basic requirements for the use of central machinery industrial dust collector:
1. It can meet the requirements of hydraulic system for filtration precision, and can prevent certain impurities from entering the system;
2. The filter element should have sufficient strength and will not be damaged by pressure;
3. Large flow capacity and small pressure loss;
4. It is easy to clean and replace, and the activated carbon filter is made of high-quality materials.
Main points of installation of central machinery industrial dust collector:
1. The oil suction strainer at the pump inlet;
2. The high-pressure oil filter on the oil circuit of the pump outlet;
3. The low pressure oil filter on the oil return circuit of the system;
4. Bypass filter system installed outside the system.
Central machinery industrial dust collector is an advanced filter equipment with reasonable structure, good sealing performance, strong flow ability and easy operation. It has a wide range of applications and strong adaptability, and is a multi-purpose equipment. In particular, the probability of filter element leakage is small, the filtration accuracy can be accurately guaranteed, and the filter element can be replaced quickly, without the consumption of materials, and the operation cost is greatly reduced. Generally suitable for liquid fine filtration in paint, viscose, resin dye, ink and oil products, chemicals and other industries.
central machinery industrial dust collector https://www.kaisenfilter.com/Products
1. The main technical parameters of soldering fume extractor selection are air volume, gas temperature, dust temperature, dust concentration and humidity. According to the maximum value of air volume, gas temperature and dust concentration according to the process design, and according to the principle of being slightly smaller than the value in the technical performance table, the corresponding dust collector model is the required dust collector model.
2. The air consumption in the table is the situation when the factory is centrally supplied with air. If the air compressor is used alone, the air consumption in the table should be enlarged to 1.5 times. In the column of compressed air consumption, the proposed air consumption is the maximum air consumption of this type of equipment.
3. For the overall dimensions of the equipment, see the attached drawings and size table. Our company can also design a dust collector that meets the user's required shape according to the user's site conditions.
Soldering fume extractor operation and instructions
1. Before the equipment is put into use, it should be checked whether the fan on the equipment is running normally, whether there is abnormal noise or bad condition, otherwise it should be shut down for repair. Check whether the electromagnetic pulse valve is working normally and whether the compressed air is at 0.5-0.7MPa, otherwise adjust it.
2. Adjustment of pulse automatic cleaning. Read the instruction manual of the pulse controller carefully, and adjust the pulse interval and pulse width. The adjustment of the pulse interval depends on the amount of dust. Generally, it can be set at about 10 seconds, and the pulse width can be set at about 0.1 seconds.
3. The dust stored in the ash collector should be cleaned regularly and regularly.
4. After the equipment is running, the dust collection effect of the equipment should be visually monitored. If it is found that there is obvious dust flying out of the clean air outlet, it means that the filter cartridge in the dust collector is loose or damaged, and it should be checked and replaced in time. The filter cartridge should be cleaned once every six months. Cleaning method: The filter cartridge should be carefully removed, rinsed with clean water and dried, and must not collide with hard objects to prevent scratching the filter material and reducing the dust collection effect. "Replacement method".
5. Regular maintenance of equipment to ensure normal operation.
soldering fume extractor https://www.kaisenfilter.com/Soldering-Fume-Extractor